礦用電纜掛鉤安裝及注意
Installation and attention of mine cable hook
安裝說明
Installation instructions
1） 根據電纜型號及外徑的大小選擇適合的電纜掛鉤，每1.2m～1.8m(也可以以電纜不下垂為限)為一個懸掛位，每一單元根據懸掛一個或多個電纜掛鉤。
1) Choose the appropriate cable hook according to the type and diameter of the cable. Every 1.2m-1.8m (also can be limited to cable sagging) is a hanging position, and each unit hangs one or more cable hooks according to the size of the cable.
2） 懸掛時，先將專門螺栓或其它懸掛件穿孔將掛鉤固定在井壁上，掛鉤固定時，弧形鉤呈垂直下垂?fàn)睢Ｈ缍喔娎|懸掛需采用一組掛鉤兩兩串聯懸掛。施工人員在地面上先將掛鉤兩兩串聯，再依前法固定。
2) When hanging, the hook is fixed on the shaft wall by perforating the special bolt or other hanging parts. When the hook is fixed, the curved hook is vertical sagging. If a plurality of cables are hung, a group of hooks and 22 series suspension should be used. The construction personnel first connect the hook 22 in the ground and then fix in front.
3） 兩個掛鉤串聯時，先將一個掛鉤的掛孔對準另一個掛鉤的掛桿，兩掛鉤的直桿段成直角，用力按入，使掛桿完全進入掛孔，然后手持弧形鉤旋轉，使兩掛鉤直桿段成180℃。一掛鉤的保險扣剛好嵌入另一掛鉤凹。
3) When the two hooks are connected in series, the hanging hole of one hook is pointed at the hanging rod of the other hook, and the straight rod segments of the two hooks are at right angles. The straight rod segments of the two hooks are pressed into the hanging hole by force, so that the hanging rods can enter the hanging hole completely, and then the hanging rod segments are rotated by the hand-held arc hook, so that the two straight rods of the hook The hook of the hook is inserted into another hook concave.
4） 確認電纜整體進入弧形鉤后，施工人員才可以放開電纜。sfacxzdfssfacxzdfs
4) confirm that after the cable enters the arc hook as a whole, the construction personnel can release the cable.