簡介General Description                   

   此液壓動力單元是用于箱式貨車尾板控制的動力裝置，該動力單元通過二位三通電磁閥和電磁止回閥實現尾板舉升、關門、下降、開門等動作，完成貨物的裝卸工作下降速度可通過節流閥進行調節。本產品為自行設計，具有安裝維護方便，操縱簡單等特點適合水平安裝使用。

This power unit uses in the power unit which the box-type freight vehicle end plate controls, this power unit realizes the end plate lifting through two Three Contacts solenoid valves and the electromagnetism check valve,to close,the drop, to open the door and so on movements, completes the cargo the loading and unloading rate of descent to be possible to carry on the adjustment through the throttle valve. This product to independently design, has installs the maintenance to be convenient, the operation simple and so on characteristics suit the level to install the use.

外型尺寸Outline Dimension                                          系統工作原理Hydraulic Circuit Diagram

型號規格說明Model Specifications         

說明：1.如需不同流量的泵、壓力、電機功率等系統參數，請查看液壓動力單元型號說明。

1.Please go to page 1 or consult our sales engineer for the different pump displacement,motor power or tank capacity.

注意事項Special Notes                  

1.安裝前必須保證油缸、油管、接頭等液壓元件清潔無任何雜質粘附。

1.Clean all the hydraulic parts concemed before mounting the power unit.

2.液壓油粘度應為15-68CST，應清潔無雜質，推薦使用N46號液壓油。

2.The viscosity of the oil shoud be 15-68 cst.

3.系統使用第一個100小時后，應更換液壓油，以后每3000小時更換一次液壓油。

3.Change the oil after the first 100 hours of using the power unit,then change the oil every 3000 hours.

4.首次啟動運行系統時，應立即檢查油箱中的油量是否充足。

4.Check the oil level in the tank after the first star of the power unit.

5.本動力單元適用于水平安裝。

5.Mounte the pump station horizontally.